@larry2
• 8 years ago
• comments: 0
Posted a response to
"Wanted: Used Dedy Guitar Cutter"
"I have a Dedy with 4 frames. $1,800 + Shipping
7.5mm base & 4 frames 37.5 mm, 30 mm, 22.5 mm, and 15 mm.
The 22.5 mm frame is missing 4..."
@larry2
• 8 years ago
• comments: 0
Posted a response to
"3 Martellato M2000 Bar Molds "
"Joe,
I found the mold listed on another website. They should be about 100 grams.
Classic break away bar approx 3.5oz, 3 cavities, 5 7/8x 3 x 3/8in,..."
@larry2
• 8 years ago
• comments: 0
Posted a response to
"silpat used as enrober belt?"
"Dallas,
I suspect the 2m take-off belt is too short. I've read that chocolates about 8 minutes in a cooling tunnel to set properly. Thus with an 8..."
@larry2
• 8 years ago
• comments: 0
Posted a response to
"JKV 30 tempering machine"
"Does the JKV 30 need 3 phase? I had a pair of older machines & they just took 220V. This required some specialized wiring, but was relatively..."
@larry2
• 9 years ago
• comments: 0
Posted a response to
"Guitar Cutter Wires Keep Breaking"
"I had string troubles as well. I ordered some 0.8 wire from TCF and while it is a lot thicker than the original 0.5 wire, I havent broken any of..."
@larry2
• 9 years ago
• comments: 0
Posted a response to
"Enro-6.daily output"
"are your belts loose? It may be a bit too large. You can shorten the belt by cutting the tubing at the union, then trimming a small piece of belt..."
@larry2
• 9 years ago
• comments: 0
Posted a response to
"How Stupid do the Mast Bros Think We Are?"
"I wish there were like buttons. Like to all the above posts."
@larry2
• 9 years ago
{jrCore_db_get_item} required parameter "item_id" is missing (modules/jrForum/templates/item_action.tpl) {jrCore_db_get_item} required parameter "item_id" is missing (modules/jrForum/templates/item_action.tpl)
{jrCore_db_get_item} required parameter "item_id" is missing (modules/jrForum/templates/item_action.tpl) {jrCore_db_get_item} required parameter "item_id" is missing (modules/jrForum/templates/item_action.tpl)
@larry2
• 9 years ago
• comments: 0
Posted a response to
"Looking for a Mini Guitar Cutter"
"I'm not aware of a standard size. the 7.5MM base worked out well for me, and we were lucky enough to find one on here.
When we hand-cut our..."
@larry2
• 9 years ago
• comments: 0
Posted a response to
"Looking for a Mini Guitar Cutter"
"Annalynn,
I saw your post about looking for a guitar cutter. I wanted to point out a few more helpful things.
There are several frames that have..."