My Hazelnut Praline Paste is Gritty

Greg Gould
@greg-gould
01/09/14 14:40:37
68 posts

I'm making my own nut pastes but I can't get them as smooth as the ones in the can. Inevitably, a few people complain it's gritty. I've tried using a Wearing commercial food processor but that's not doing the trick. Would a robo-coupe be better or am I not going to be able to get it perfect with a fod processor?


updated by @greg-gould: 04/15/15 14:17:47
Ruth Atkinson Kendrick
@ruth-atkinson-kendrick
01/09/14 15:32:34
194 posts

I don't think you can get it smooth with a food processor. Definitely not at Robot Coupe. They only have a 5 minute duty cycle, not nearly enough time to get it smooth. There is specialty equipment for this.

Clay Gordon
@clay
01/09/14 15:49:24
1,680 posts

Greg -

When you say praline I am assuming pralin. Nuts cooked in sugar?

If you were just grinding nuts then this would be no problem. The challenge is the caramelized sugar. That's what you're having trouble grinding fine. The style for this kind of pralin is a l'Ancienne. You may find that you want/need a roll mill to refine this.




--
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
clay - http://www.thechocolatelife.com/clay/
Lee2
@lee2
01/09/14 16:53:32
33 posts
Another choice is to go the other way. Make it even corser and sell it as 'chunky' or 'rustic' ;-)
Sweet matter physicist
@sweet-matter-physicist
01/10/14 06:13:31
8 posts

It could also be that longer processing is already enough. I was doing pralin with a Magimix (which should be roughly equal to your Wearing food processor), and it really took at least 10-15 minutes of processing until the paste was OK. Only to be sure: I used roasted nuts thrown into caramelized sugar, let them cool down, and then put the caramel-nut pieces into the food processor.

If you want to make a nut paste and no pralin, it is very similar. It also takes at least 10 minutes of processing before the nuts properly release their oil. In addtion, the type of nuts used makes a big difference. I would say, the higher the fat content, the easier to make a paste (e.g. Pecan nuts...). Alternatively, it helps to add a little bit of oil to the nuts before or during processing, such as some nut oil or a neutral tasting oil.

However, the earlier comments are all true, you'll never get a perfectly smooth pralin paste or nut paste with a food processor. There will always be a perceivable 'graininess', but for fillings I found it still fairly good and usable!

Greg Gould
@greg-gould
01/10/14 06:44:28
68 posts

Yes I meanpralin. Thank you everyone for your answers. I'm glad I didn't buy the Robot Coupe.

Greg Gould
@greg-gould
01/10/14 06:50:19
68 posts

Would someone provide links to some roll mills?

Clay Gordon
@clay
01/10/14 09:21:36
1,680 posts

Greg:

I am in the midst of working on a relationship with an Italian roll mill manufacturer (stone rollers) that makes 2- and 3-roll mills designed for making nut pastes, smooth pralins, and giandujas that can also be used in making chocolate from the bean. The throat widths are > 300mm.

You can get small lab 2- and 3-roll (steel) mills made here in the US with 125mm (~5") throats designed for working with paints and cosmetics. These use steel rollers and are for lab use. They might have enough throughput for your need.

I will be getting prices shortly and let you know what I find.




--
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
clay - http://www.thechocolatelife.com/clay/
Greg Gould
@greg-gould
01/10/14 11:07:35
68 posts

Thank you Clay!

chocochoco
@chocochoco
01/11/14 05:40:34
56 posts

Hi Clay, would a melanger/grinder such as the cocoatown one do this job fine?

http://www.cocoatown.com/index.php/melangers/new-melanger.html

Or this other one:

http://www.nutbuttergrinder.com

Thanks,

Omar

Clay Gordon
@clay
01/12/14 11:03:41
1,680 posts

Omar:

I have never used either of these machines to make pralin, so I don't know from experience.

There's not a whole lot of difference between to the two outside the configuration of the stones.

The one at nutbuttergrinder.com is more like a small Santha. I would go with the CocoaTown 12SLTA over the straight SL as I think it's more robust and the tension is more easily adjustable.

I have used the CocoaTowns to make nut butters using unrefined evaporated cane juice and I can say that they do a good job of making a rustic pralin, which is what I was looking to do. You still have the same problem of jamming the rollers if you try to fill the machines too quickly - there's just not enough torque provided by the motor/belt. So you do have to start out slowly and add the nuts a little bit at a time. I never ran the pralin for more than a couple of hours, but I imagine that if you ran it long enough you'd be able to grind the sugar to the point it wasn't detectable.




--
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
clay - http://www.thechocolatelife.com/clay/
chocochoco
@chocochoco
01/13/14 09:12:40
56 posts

In two courses thatI attended, we made our own praline using a Robot Coupe Blixer 3. The praline was used for filling. The result was very good.

Kristofer Kalas
@kristofer-kalas
01/13/14 14:03:44
9 posts

If you want to go the other route (and invest 25K) -Selmi Micron Ball Refiner is what we use.

Micron - ball refiner

Tags

Member Marketplace


Activity

kapil jain
 
kapil jain
 
kapil jain
 
@kapil-jain • 7 years ago

Chocolatevenue is an online chocolate store in India.We are specialized in customized chocolates  .Chocolates can be customized as chocolate message and chocolate bars.

You can get written your message on chocolates and can get customized your chocolate bars by selecting the desired ingredients.

for more details

 

colorchocolate
 
@colorchocolate • 7 years ago

FOR SALE / BARGAIN / FINE CACAO LIQUOR, COLOMBIA ORIGIN

Enjoy a delicious premium chocolate from the Boyacá region of Colombia, considered among the best in the world. We offer a 200 kilograms lot of pure origin cocoa liquor,  fair trade / ethically sourced. N o other ingredients added.

The price for this high quality product is as follows:

1 kg - US$ 13

100 kg - US$ 12 per kilo

200 kg - US$ 11 per kilo

Inquires: equalcolombia@gmail.com

- See more at: https://www.thechocolatelife.com/colorchocolate#sthash.JFDWYFuK.dpuf

- See more at: https://www.thechocolatelife.com/community/forums/my_posts/18453/fine-cacao-liquor-colombia-origin#sthash.2pUq4Eu3.dpuf

Clay Gordon
 
@clay • 7 years ago

FCIA Recognition of Excellence Nominations close in one week:

Clay Gordon
 
The 4 Chocolatiers
 
@the-4-chocolatiers • 7 years ago

Two changes we made with the chocolate is that this time we winnowed the chocolate. This time we didn't use a blow dryer to melt the chocolate. Two improvements with the chocolate is that the melanger didn't get clogged this time and everyone put in work.